One axis controller driver with a power supply voltage is DC24V. It can be used even at 100V with the dedicated AC adapter.
Equipped with a low vibration driver. Achieves lower vibration drive than conventional drivers.
Jog movement, step movement, teaching operation, one-touch speed switching, etc. are possible with the operation box QT-AK.
The program created by the "QT-EDIT" is stored, and automatic operation of only the controller driver is possible."QT-EDIT" is dedicated application software attached as standard.
The unit display of the operation box (mm, μm, decimal degree, degrees, minutes, and seconds can be simply displayed with symbols, etc.) is possible.
RS-232C is installed as standard as an interface for PC.
It can be connected to other devices by inputting and outputting various signals, such as general-purpose input/output terminal, drive pulse output, move/stop output, built-in program CH selection.
The S-shaped drive function that enables smooth acceleration and deceleration by trapezoidal drive is installed as standard.
Equipped with a general-purpose input and output terminal (input/output, 4 points/16 ports).
Equipped with an electromagnetic brake control function. Electromagnetic brake control is possible by combination of QT-BK (sold separately).

*Before use
For QT-BDL1, QT-BDL1(K) and QT-BDL1(K)AC, please set the motor drive current (phase current) before use.
Change the RUN rotary switch on the motor driver unit built into QT-BDL1. The factory setting is 0.75A/phase.